Impulse 150PoE Manual do Utilizador descarregar pdf (Página 30)

©Sealevel Systems, Inc.

SL9049 - 03/2011

eI/O Manual

Type

Cd “C:\Program Files\Sealevel Systems\SeaMAX\” and then press Enter

When the command calls for iii.iii.iii.iii you substitute the unit‟s IP address. Please do not enter

the numbers with a leading zero. Therefore, if your IP address is 192.168.42.11, you will enter

192.168.42.11 and not 192.168.042.011. The command for this is therefore:

iocu /i=192.168.42.11 /a=247 120.hex

Once the unit has received the download request it will turn on the ACT light . Once the

download starts, the ACT light will flash rapidly as data is downloaded. Once the download is

complete, the ACT light will remain on while the device is reprogramming itself.The unit will

then reboot itself to reload the new firmware. At this point, the ACT light will turn off.

The above should only be performed if you (1) really feel the update is required and (2)

you feel confident in your ability to perform the update. Once the firmware has been

erased, you must either be able to re-program it locally or send it back to SeaLevel

Systems, Inc. for reprogramming.

To upgrade your firmware through MaxSSD, connect to your device normally, then go to the

“Advanced” tab. At this point, you can use the “…” button to browse for the *.hex file you wish

to update your device with.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37

Sem comentários

Impulse 150PoE Manual do Utilizador Página 30