Impulse 2801 Manual do Utilizador

SeaLINK+8/USB TM Part # 280XSealevel Systems, Inc P.O. Box 830 Liberty, SC 29657 USA Phone: (864) 843-4343 FAX: (864) 843-3067 www.sealevel.com

Specifications Sealevel Systems SeaLINK+8 Page 7 Technical Description The SeaLINK+8 utilizes eight USB UARTs. These chips feature programmable baud

Specifications Sealevel Systems SeaLINK+8 Page 8 Specifications Environmental Specifications Specification Operating Storage Temperature Range 0º t

Appendix A – Troubleshooting Sealevel Systems SeaLINK+8 Page 9 Appendix A - Troubleshooting Serial Utility test software is supplied with the Seale

Appendix B – How To Get Assistance Sealevel Systems SeaLINK+8 Page 10 Appendix B - How To Get Assistance Please refer to Appendix A - Troubleshoo

Appendix C - Electrical Interface Sealevel Systems SeaLINK+8 Page 11 Appendix C - Electrical Interface RS-232 Quite possibly the most widely used c

Appendix C - Electrical Interface Sealevel Systems SeaLINK+8 Page 12 RS-485 RS-485 is backwardly compatible with RS-422; however, it is optimized f

Appendix D - Asynchronous Communications Sealevel Systems SeaLINK+8 Page 13 Appendix D - Asynchronous Communications Serial data communications im

Appendix E - Compliance Notices Sealevel Systems SeaLINK+8 Page 14 Appendix E - Compliance Notices Federal Communications Commission Statement FCC

Warranty Sealevel Systems SeaLINK+8 Page 15 Warranty Sealevel Systems, Inc. provides a lifetime warranty for this product. Should this product fail

Contents INTRODUCTION... 1 OVERVIEW...

APPENDIX E - COMPLIANCE NOTICES... 14 FEDERAL COMMUNICATIONS COMMISSION STATEMENT ...14 EMC DIRECTIVE STATEM

Introduction Sealevel Systems SeaLINK+8 Page 1 Introduction Overview The Sealevel Systems SeaLINK+8 family of products equips the PC with 8 USB to

Installation Sealevel Systems SeaLINK+8 Page 2 Installation Operating System Installation Choose Install Software at the beginning of the CD and i

Installation Sealevel Systems SeaLINK+8 Page 3 You can access your new COM: ports by using the assigned COM: identifiers as shown above. In thi

Configuration Sealevel Systems SeaLINK+8 Page 4 Configuration Factory configuration Each device ships from Sealevel Systems with the following conf

Configuration Sealevel Systems SeaLINK+8 Page 5 Below is a figure of dipswitches SW1, SW2, SW3, and SW4. Each switch has a total of twelve position

Configuration Sealevel Systems SeaLINK+8 Page 6 Interface Biasing Configuration The last four positions for each port are used to select the line te