Impulse 463N Manual do Utilizador descarregar pdf (Página 13)

©Sealevel Systems, Inc.

SL9049 - 11/2010

SeaI/O Manual

All SeaI/O modules include the same connectors and configuration options on the side of the unit:

RS-485 networks should have termination enabled on each end of the network. Pull-up and

pull-down resistors should also be enabled on the last device on the network. The 9-30VDC

input barrel connector is center positive.

Status LEDs are also included on the front of all SeaI/O modules to indicate the following

information:

 Communication (Yellow) – Blinks when data is transmitted

 Fault (Red) – Lights when there is a problem with the device

 Status (Green) – See Device Address Configuration section of this manual

o Blinks when the rotary “ADDR” switch is set to “0” and the default Slave ID is set to 247

o Lights steady when module is properly configured from the factory defaults

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 108 109

Sem comentários

Impulse 463N Manual do Utilizador Página 13